Only allowing VMs network access.

Moderator: continuum

Only allowing VMs network access.

Postby TheWHAMBurglar » Sat Nov 13, 2010 8:05 am

It has been too long since I last used MOA, sadly, I have forgotten too much. In particular, I had forgotten if there was a way in which only VMs, not MOA itself, can access any given network.

Perhaps I should clarify:
MOA by itself is deemed vulnerable and considered unusual by any network scanner. I simply seek to isolate MOA from network access. Basically to prevent the MOA operating system from sending packets over any interface except VMware’s virtual interfaces. Only to allow VMs to send packets over any interfaces so that it would seem as if only a VM connected to a network.
Posts: 4
Joined: Thu Nov 04, 2010 6:36 am

Re: Only allowing VMs network access.

Postby continuum » Mon Nov 15, 2010 11:27 pm

Yep - that is possible.
After boot - and before you start any VMs you would remove all protocols other then the vmware bridge protocol from the nic used for bridging.

Then a scanner will only see the VMs.

Sorry - right now I don't know how to automate this - maybe you can create an autoit script that clicks through it ?

Posts: 57
Joined: Tue Sep 28, 2010 8:39 pm

Return to MOA - based on BartPE

Who is online

Users browsing this forum: No registered users and 0 guests